Simultaneous 3-axis linear interpolation enables smooth and speedy 3D engraving.
ME-500 : 483X305mm(19X12")
ME-650 : 650X440mm(25.6X17.3")
Long materials can be set along the front-back direction. Maximum material widths are 650mm(25.6") for the ME-500 and 750mm(29.5") for the ME-650.
Spindle can move up to 60mm(2.4") above table and allows materials of up to 50mm(2.0") to be set.
The ME-500/ME-650 are equipped with a chip removal attachment and an adaptor to a vacuum pump.
Typical vacuum pump* can be easily attached to the adaptor.
Optional Vacuum Pump Controller turns on/off power to the vacuum pump so it will run only when engraving.
*Vacuum pump is not included.
A computer can send jobs to the ME-5--/ME-650's one megabyte memory buffer without waiting for the ME-500/ME-650 to finish engraving.
The computer therefore can be used for another fob while the ME-500/ME-650 are engraving.
Also, data stored in the memory can be used to engrave the same job.
2182-3 Shigeno-Otsu, Tomi-city, Nagano, Japan
(C) MIMAKI ENGINEERING CO., LTD. All Rights Reserved.